MRWA Supplement to Austroads Guide to Road Design - Part 8

Document No:  D11#308846
 
Revision:  2B
 
Date amended:  24-Sep-2015

Image: orange line.RCN-D13^23151823.GIF 

 

The information below is intended to reflect the preferred practice of Main Roads Western Australia ("Main Roads"). Main Roads reserves the right to update this information at any time without notice. If you have any questions or comments please contact Con Magriplis by e-mail or on (08) 9323 4540.

To the extent permitted by law, Main Roads, its employees, agents, authors and contributors are not liable for any loss resulting from any action taken or reliance made by you on the information herein displayed.

Revision Register

 

Ed/Version Number Clause Number Description of Revision Date

1

All

Guideline Developed. 09-Dec-2011 
​2​2, 3, 4​References to Main Roads Guidelines added.​28-Jul-2015
​2A​6​Reference to Main Roads Guideline added.​29-Jul-2015
​2B​1.1​Text reworded.​24-Sep-2015

 


Table of Content


MRWA Supplement to Austroads Guide to Road Design

Part 8 - Process and Documentation.

 
This Supplement has been developed to be read in conjunction with Austroads Guide to Road Design (GRD) Part 8: Process and Documentation (2009), a copy of which can be purchased via the Austroads website.
 
In Western Australia, state-based information, on this website and elsewhere, takes precedence over Austroads Guides and Standards Australia Standards. National Guides and Standards take precedence over International Guides and Standards, unless specifically stated otherwise.
 
This Supplement has the same structure as the equivalent Austroads Guide and only additional requirements, clarifications, or practices different from Austroads appear.  Where appropriate, this Supplement may also contain additional sections and figures not covered by Austroads, but the numbering sequence found in the Austroads Guide remains. Figures and tables in this Supplement replace those with the same figure or table number in the equivalent Austroads Guide. 
 

 

1. INTRODUCTION

1.1 Scope of this Guide

Main Roads requires designs to conform to the Quality Management Systems and Requirements as set out in AS/NZS ISO 9001:2008.



2. PREPARATION FOR DESIGN

Refer to the Main Roads guideline "Standard Design Brief" for further and specific information.


3. DESIGN DEVELOPMENT

Refer to the Main Roads guideline "Design Report Guideline" for further information.


4. DESIGN REVIEW, VERIFICATION AND VALIDATION

Refer to the Main Roads guideline "Design Review" for further information.


5. DESIGN AUDIT PROCESS

Main Roads has no supplementary comments for this section.


6. PRESENTATION OF OUTPUTS

Refer to the Main Roads guideline "Design and Drawing Presentation" for further information.



7. REFERENCES

Main Roads has no supplementary comments for this section.